Skip to content
AC and furnace help in the Wixom areacontact@gottavia.living
Gottavia Heating & Air
No heat? Start with safety, then price.

Furnace Repair Services in Wixom

Request an estimate today

A furnace that quits in winter is a real problem. The ground has deep frost and the house cools fast. Start with safety. If you smell gas, leave and call your gas utility from outside. If not, a few simple checks may bring the heat back. Many fixes are small parts, like an ignitor or a sensor. A local provider can find the cause and explain it plainly.

This page shows what drives the price and what typical U.S. ranges look like. It also covers when repair makes sense and when replacement is the better move. Providers in our network are independent. Gottavia Heating & Air connects you with one. It does not do the work. Ask for a written quote before anyone starts. Price it first, then decide.

Smell Gas? Leave First

A rotten-egg smell means get out. Do it now.

Do not flip switches. Do not use a lighter. Do not use a phone inside. Walk outside, then phone your gas utility or 911 from a safe spot. Stay out until they say it is clear.

Repair comes later. Safety comes first.

Carbon Monoxide Is a Separate Alarm

If a CO alarm sounds, get fresh air and get everyone out. Headache, nausea and dizziness are warning signs. Phone 911 from outside.

A cracked heat exchanger or a blocked vent can cause CO. That is why working alarms matter near every sleeping area.

Furnace Out in a Cold Snap

No heat is urgent when frost runs deep. Pipes in a basement or crawl space can burst once the house gets cold enough.

Close doors to rooms you do not use. Keep the warm air in one area. If you use a space heater, follow its directions and keep it clear of anything that burns.

Many providers can respond quickly in cold weather. Availability varies. Request a callback to check provider availability.

Get Started

Checks You Can Do in Five Minutes

Try these first. They fix more calls than you might expect.

  • Set the thermostat to heat. Put it a few degrees above room temperature. Swap the batteries.
  • Look at the breaker. Check the switch near the furnace too. It looks like a light switch.
  • Pull the filter. A clogged one can shut the furnace down.
  • Make sure the gas valve handle runs in line with the pipe.
  • Close the blower door fully. A safety switch stops the burner if it is loose.
  • On a high-efficiency unit, look for a clogged drain line.

Stop there. Do not open the burner area. Do not touch wiring.

Signs Your Furnace Needs Repair

Some signs are loud. Some are quiet.

  • Cold air from the vents
  • Short bursts of heat, then off
  • Bangs, squeals or rattles
  • A yellow or flickering burner flame
  • Rooms that stay cold
  • A gas bill that keeps climbing
  • A burner that will not light

Why Small Signs Matter

Small problems grow. A dirty sensor today can wear out a control board later.

Write down what you see and hear. Note when it happens. A provider can use those notes to find the cause faster.

What a Repair Visit Looks Like

The provider starts with the basics. Thermostat, power, gas, filter, vents.

Next comes the error code. Most furnaces flash a light on the control board. It points to the problem.

Then the provider tests the safety parts. You should hear the cause in plain words and see the options. Ask for a quote before parts are ordered or work starts.

Parts Providers Fix Most Often

Ignitor and Flame Sensor

The ignitor lights the burner. The sensor confirms the flame. Both wear out. Both are common, modest repairs.

Blower Motor and Capacitor

The blower pushes warm air through the house. A weak capacitor can stop it. A failed motor costs more.

Inducer Motor and Pressure Switch

These move exhaust out safely. If they fail, the furnace shuts itself off on purpose.

Control Board

The board runs the whole sequence. Burnt spots or repeat faults often point to it.

Cracked Heat Exchanger

This one is serious. It can leak exhaust into the air you breathe. Most providers advise replacing the furnace when it is confirmed.

What Drives the Price

Five things move the number.

  • The part itself
  • Labor time
  • Furnace age, since older units can have harder-to-find parts
  • Access, such as a tight basement corner
  • The season, since winter demand can raise prices

See the table above for typical U.S. ranges. Your job may land outside them.

Quote in Writing

Get the quote on paper or by text. Look for parts, labor and any diagnostic fee as separate lines.

Ask if the diagnostic fee applies toward the repair. Ask about warranty on parts and labor. Ask what happens if the first fix does not solve it.

Price it first. Then say yes.

Get Started

Repair or Replace?

Furnaces often last 15 to 20 years. Age is the first clue.

A rough rule: if the repair costs about half of a new unit and the furnace is old, replacement deserves a look. A cracked heat exchanger, repeat breakdowns and climbing bills point the same way.

A young furnace with one bad part? Repair it.

Know Your Options

You usually have three paths.

  • Repair now and keep the furnace
  • Repair now and plan a replacement for later
  • Replace the furnace

Ask for each in writing. If you search furnace replacement near me, expect a separate quote with equipment, labor and removal listed. Replacement is its own job, so compare it side by side with the repair.

Old Houses, Basements and Frost

Many homes here are frame houses, bungalows or ranches with decades behind them. Older ductwork can leak heat. Dusty basements clog filters faster.

Spring flooding and sump pump trouble matter too. If water reached the furnace or its controls, do not run it. Have a provider inspect it first.

Some policies may cover sudden damage. Check your policy. Providers can often help document damage for a claim.

Questions to Ask the Provider

  • What is the cause, in plain words?
  • What does the quote include?
  • Is the diagnostic fee separate?
  • What are my options, and what does each cost?
  • Is the part new, and what warranty comes with it?
  • Is the furnace safe to run today?

Before Next Winter

Book a heating and cooling check in the fall. Any HVAC service visit should include burners, vents and safety switches. Change filters on schedule. Keep vents clear. Test your CO alarms.

Summer trouble is a different job. Emergency AC repair has its own page.

If the heat is out now, Request a callback to check provider availability.

Get Started

What's Included

Fault Diagnosis

A provider checks power, gas, thermostat and error codes to find why the furnace stopped heating.

Part Replacement

Worn ignitors, sensors, motors and boards can be swapped when the unit is worth fixing.

Safety Checks

Vents, flame, and heat exchanger are inspected so the furnace is safe to run.

Written Quote

You get costs for parts and labor in writing, plus repair and replacement options, before work starts.

What Repairs Typically Cost

These are typical U.S. ranges. Your job may cost more or less. Part, labor, furnace age and access all change the total. Get a written quote before any work begins.

ItemTypical rangeNotes
Diagnostic visit$75 – $200Ask if it applies toward the repair
Ignitor$150 – $450Common wear part
Flame sensor$100 – $300Often a quick fix
Blower motor$400 – $1,500Varies by motor type
Control board$300 – $900Depends on make and model
Heat exchanger$1,500 – $3,500Often leads to replacement

Get Started

How It Works

Check Safety First

Smell gas or hear a CO alarm? Get outside and phone your gas utility or 911 before anything else.

Try Quick Checks

Check the thermostat, breaker, filter and gas valve. Do not open the burner area.

Request an Estimate

Send the request form or Request a callback to check provider availability in your area.

Review the Written Quote

Compare repair and replacement lines. Ask questions. Approve only when it makes sense.

Why Call Gottavia Heating & Air

Price It First

Know what drives the number before a provider starts. Ranges here help you spot a quote that looks off.

Quote in Writing

A written quote lists parts and labor. It keeps everyone clear on the plan.

Know Your Options

Repair, repair and plan, or replace. You see each path before you pick.

Independent Providers

Providers in our network are independent. Gottavia Heating & Air makes the connection and does not do the work.

Other Services

Need furnace repair services in Wixom?

Heating or cooling trouble? Send a request or ask about provider availability. Tell us what is going on and a local provider can follow up with next steps.

No obligation
FAQ

Furnace Repair Services FAQ

How much does furnace repair cost?

Many repairs land between about $150 and $1,500 in the U.S. A sensor costs far less than a blower motor. A heat exchanger can run into the thousands. Always get a written quote first.

Why is my furnace blowing cold air?

Common causes are a thermostat set wrong, a clogged filter, a dirty flame sensor or an ignitor that failed. Check the simple items, then ask a provider to test the rest.

Should I repair or replace a 15-year-old furnace?

It depends on the problem. A small part on a working unit is often worth repairing. A cracked heat exchanger or repeat breakdowns usually favor replacement. Ask for both quotes in writing.

Contact Us

Get in touch

Heating or cooling trouble? Send a request or ask about provider availability. Tell us what is going on and a local provider can follow up with next steps.

No obligation
Request a callback